Category: Engineering

An important factor in the further development of Industry 4.0 and Digital Twins is the education and training of professionally competent engineers in digital technologies for I4.0.

Testbeds

To educate the next generation of engineers, Testbeds…

To elucidate the dynamic evolution mechanisms of overburden fractures under repeated mining controlled by multi-layer key strata, a three-dimensional physical similarity simulation system was developed based on the spatial superposition theory of…

Pelican optimization algorithm

The Pelican Optimization Algorithm¹⁶ (POA) was proposed by Pavel et al.in 2022 under the influence of the behavior and strategic behavior of the hunting. The pelican has a large body, a long mouth, and a large bag in…

Initial experimentations

Based on earlier study and initial experimentations³⁴, the necessary welding parameters have been selected. For weld in longitudinal configurations, seven sets of different weld specimens were prepared. Initially, only…

This section presents the investigation results of the parameters affecting the rut depth caused by the pneumatic and track wheel passage.

Analysis of variance (ANOVA) is a statistical method used to compare multiple groups’ means and determine…

Study design and population

The cohort data used in this study is the eICU Collaborative Research Database and the Medical Information Mart for Intensive Care (MIMIC-IV v. 2.0, July 2022), public ICU databases available upon request and fulfilment…

In this section, the proposed SCB-Darknet53 backbone network is introduced firstly, and then the enhanced asymptotic feature pyramid network (AFPN), and finally the architecture of the proposed SCB-AF-Detector in detail.

SCB-Darknet53 backbone…

AISC 360

AISC 360 specifications primarily address prismatic members, with shear strength predictions based on section-by-section evaluations. However, applying these methods on the girders with opening in the web panel have notable limitations,…

Tensile strength evaluation

The tensile test result of the composites is shown in Fig. 1, from the mean of three specimens from each sample. The tensile strength of the neat resin sample (S1) achieved was 12 MPa. The addition of PALF and roselle…

In order to achieve asymptotic consensus in AC MG, DGs should communicate to each other to restore the voltages and frequency of MG and real power sharing. In this section, we have developed the new protocols based on fully distributed…