Category: 4. Physics

Slump cone

The incorporation of RCA in concrete mixtures typically results in a decrease in slump compared to concrete made with natural aggregates, even when using the same water-cement ratio³². This reduction in workability is attributed to the…

Fringe visibility and source size calculations

Interferometric fringes have been observed at all the energies explored during the experiment. Coherence length calculations were not performed on data taken at energies above \(E=15\) keV due to…

Scheme for generating the 2D cluster state

As is shown in Fig. 2a, the 2D cluster state can be generated by 4 steps. In step I, the pumped beam composed of Hermite Gaussian (HG) modes HG\(_{02}\) and HG\(_{20}\) is injected into the cavity, in…

Near-IR comb generation

The system shown in Fig. 1a is similar to that described to generate frequency combs in the THz region based on difference frequency generation⁴¹. As mentioned in this prior work, this same approach is applied here to…

YH₂ has a fluorite structure and belongs to the cubic Fm̅3m space group. The Y atoms form a fcc lattice with the H atoms occupying the tet sites as shown in Fig. 1(a). In an alternative representation, the H atoms are positioned in a simple…

Non-thermal microwave plasma optical characterization

Figure 2 illustrates the optical emission spectrum spanning the wavelength range of 300–1000 nm, characterizing air (0.8%) and ozone (99.2%) plasma generated via a microwave source,…

All chemicals, cell lines, media, antibodies, fluorescence probes, commercial assays, and tools used in this study are listed in Table S1 (Supplementary Information).

Experimental sources of Far-UVC irradiation

In this study, we used two Far-UVC…

Steady-state photoluminescence spectroscopy

The structure under study is schematically depicted in Fig. 1a. The active region consists of twelve 9 nm-wide Al_0.20Ga_0.80As QWs, separated by 4 nm AlAs barriers, distributed in three stacks of four….