Category: Engineering

Deformation and deviation modes of the mover

There are various factors that may cause the deformation and deviation of the mover. For example, the manufacturing or assembly error may make the mover not at the center of the electrical machine,…

Effect of load pulse period on the response of the experimental configuration

The load pulse period primarily reflects the target spacing and penetration velocity in multi-layer targets, representing the excitation period during projectile-target…

In this study, the effects of thermoplastic PLA materials with different 3DP parameters on mechanical tests were investigated. The average values of the mechanical test results are listed in Table 3. Statistical analysis was performed using the…

Flow properties

The concrete slump is presented in Fig. 9. The slump of JF50 is the maximum (27.5 cm), showing the best flowability. Besides, the concrete slump decreases with increasing basalt fiber and steel fiber contents. For example, the…

The study’s results revealed that histoanatomic differences between aganglionic and ganglionic bowel wall could be identified clearly with UHFUS in bowel examined ex vivo. Specifically, we found that the muscularis interna was thicker and the…